bms_w062_sw_ctr_pwr_supply
Do not driveTesla · BMS system
Battery Management System — Contactor Power Supply Too Low
What it means
The main battery contactors need a healthy low-voltage supply to stay closed. The BMS detected that the voltage feeding the contactors dropped below its threshold — so it can't guarantee the pack stays connected, and the car shuts down driving, charging, and 12V support. This is frequently a low-voltage (12V) system problem rather than a pack problem.
Symptoms
- "Service needed — pull over safely" warning
- Car may shut down or refuse to start
- Unable to charge
- May follow flickering electrical behavior or a dying 12V battery
Likely causes (by probability)
- 1.Weak/failing 12V batteryHigh
- 2.Failing DC-DC converter not maintaining the low-voltage systemMedium
- 3.Wiring or connector fault in the contactor supply feedMedium
What you can check yourself
- 01Pull over safely and check the 12V battery — age, voltage, and condition.
- 02A fresh 12V battery plus a power-cycle may restore normal operation.
- 03Note whether the alert appeared with other low-voltage warnings.
- 04If a healthy 12V doesn't fix it, the DC-DC converter or supply wiring needs Tesla Service.
EV systems involved in bms_w062_sw_ctr_pwr_supply
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
High-voltage distribution & safety
Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.
Severity
Don't keep driving on this one. Check the 12V battery first; if that's not it, tow to service.
Estimated repair cost
Dealer / service center
— – —
Often resolved by an inexpensive 12V battery. DC-DC or wiring repairs vary — covered under warranty in many cases; get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_w034_sw_isolation_sensorBattery Management System — Isolation Sensor Fault
- bms_w139_sw_dc_link_v_irrationalBattery Management System — DC Bus Voltage Sensor Reading Nonsense
- bms_a051_sw_hvc_vref_badBattery Management System — High-Voltage Controller Reference Voltage Off
- bms_a143_sw_cac_changeBattery Management System — Large Capacity Estimate Update