bms_w070_sw_iso_fast_flood
Do not driveTesla · BMS system
Battery Management System — Sudden Loss of Isolation While Driving
What it means
While the car was being driven, the BMS detected a sudden loss of high-voltage isolation — the electrical barrier between the high-voltage system and the car body collapsed quickly. A fast drop like this often points to water ingress or physical damage. The pack contactors won't close again, so the car can't drive until it's repaired.
Symptoms
- Sudden loss of drive while underway
- "Service needed — pull over safely" warning
- Car won't restart afterward
- Often follows driving through deep water, flooding, or an impact
Likely causes (by probability)
- 1.Water intrusion into the battery pack or a high-voltage component (flood, deep water)High
- 2.Collision or underbody damage breaching high-voltage insulationMedium
- 3.Sudden internal failure of a high-voltage componentLow
What you can check yourself
- 01Pull over, power off, and stay clear of any damaged areas — treat the car as electrically compromised.
- 02Recall and record exactly what preceded it: water, impact, road debris.
- 03Do not open any covers or touch orange high-voltage cabling.
- 04Tow to Tesla Service; if water was involved, say so — it changes the safety protocol.
EV systems involved in bms_w070_sw_iso_fast_flood
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Body domain controllers
Distributed controllers around the car (front, left, right, doors, seats, charge port) that run lights, latches, wipers, windows and actuators, and report state back over the vehicle network. A mismatch between what a latch says and what the network sees is a classic body-domain fault.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
High-voltage distribution & safety
Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.
Severity
This is a genuine shock-hazard scenario. Do not drive or retry starting — tow to service and report any water or impact history.
Estimated repair cost
Dealer / service center
— – —
If water or collision damage is involved, insurance often applies; otherwise battery warranty may cover it — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_f142_sw_isolation_degradatioBattery Management System: Isolation Degradation Warning
- bms_u030_unsupportedadapterBattery Management System — Unsupported Charging Adapter (Arc Flash Risk)
- bms_w079_sw_ctr_pwr_interruptedBattery Management System — Contactor Power Interrupted
- bms_a079Battery Management System — Cell Voltage Imbalance