All codes

bms_w096_sw_fast_charger_mia

Drive with caution

Tesla · BMS system

Battery Management System — No Communication From the Fast Charger

What it means

During a DC fast-charging session, the BMS isn't receiving the required messages from the external charging station. The result: fast charging fails, but AC charging continues to work normally. Very often the problem is the station or its cable rather than the car.

Symptoms

  • DC fast charging won't start or drops out
  • AC (home / Level 2) charging works fine
  • Car drives normally
  • Problem may follow you only to certain stations

Likely causes (by probability)

  1. 1.Faulty or incompatible fast-charging stationHigh
  2. 2.Damaged station cable/connector or dirty charge-port pinsMedium
  3. 3.Car-side charge port or communication wiring faultLow

What you can check yourself

  • 01Try a different stall, then a different network — if other stations work, the station was the problem.
  • 02Visually inspect the charge port pins for debris or damage (look only).
  • 03Confirm AC charging still works normally.
  • 04If every DC station fails, schedule service for the car-side charge path.

EV systems involved in bms_w096_sw_fast_charger_mia

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

Drive unit (motor + inverter)

The inverter switches battery DC into the variable AC that spins the motor, and the resolver (position sensor) tells it exactly where the rotor is. Torque control is only as good as that position feedback and the inverter's thermal headroom.

Vehicle network (CAN / gateway)

Multiple CAN buses link every controller; the gateway routes messages between them and to diagnostics. "MIA" (missing in action) alerts almost always mean a node stopped sending on its bus — the cause can be the node itself, its wiring, or its power supply.

Severity

Drive with caution

Drive and AC-charge as normal. Only escalate to service if multiple different DC stations all fail.

Estimated repair cost

Dealer / service center

— – —

Usually the charging station, not the car — no cost. Car-side charge-port repairs vary; covered under warranty in many cases — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site