All codes

bms_w037_sw_pos_contactor

Do not drive

Tesla · BMS system

Battery Management System — Positive Contactor Stuck or Welded

What it means

The positive main contactor — one of the two big relays connecting the pack to the car — didn't close (or didn't behave) as commanded when the BMS tried to power up. The BMS suspects it's welded or broken. With the contactor path faulty, the car can't drive, charge, or support the 12V system from the pack.

Symptoms

  • Car won't start
  • Unable to charge
  • "Service needed" warning
  • May follow repeated high-current events or an over-current alert history

Likely causes (by probability)

  1. 1.Contactor contacts welded shut or eroded from opening under loadHigh
  2. 2.Contactor coil or driver circuit failureMedium
  3. 3.Wiring fault in the contactor sense circuit causing a false readingLow

What you can check yourself

  • 01Don't keep attempting restarts — each attempt stresses the contactor circuit further.
  • 02Photograph the alerts and note any history of power cutouts.
  • 03Check whether over-current counter alerts (like bms_w023) have been logged.
  • 04Contactor replacement is inside the sealed battery pack — Tesla Service only, never DIY.

EV systems involved in bms_w037_sw_pos_contactor

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Low-voltage (12V/16V) system

The small battery and DC-DC converter that power every computer, relay, contactor coil and sensor in the car. EVs are famously sensitive to a weak low-voltage battery — it causes cascading "ghost" faults across unrelated systems.

High-voltage battery pack

The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.

High-voltage distribution & safety

Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.

Severity

Do not drive

A failed main contactor means the pack can't safely connect. Tow the car to Tesla Service.

Estimated repair cost

Dealer / service center

— – —

Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site