bms_w102_hw_bmb_thermal_shutdown
Do not driveTesla · BMS system
Battery Management System — Battery Module Overtemperature Shutdown
What it means
A battery monitoring board has reported a module temperature above the safety threshold, triggering a thermal shutdown of the high-voltage system. The car shuts down or refuses to drive, charge, or support the 12V system. Overheating modules are a genuine safety concern, so the car is not being dramatic.
Symptoms
- Vehicle shuts down — red critical warning
- "Pull over safely" instruction
- Unable to charge or restart while hot
- May follow fast charging, hard driving, or hot weather
Likely causes (by probability)
- 1.Battery cooling system failure (pump, valve, low coolant)High
- 2.A module genuinely overheating due to an internal faultMedium
- 3.A faulty temperature sensor reporting false heatLow
What you can check yourself
- 01Pull over, power off, and let the car cool — don't keep driving an overheating battery.
- 02Check for coolant warnings or visible leaks.
- 03Note the conditions: outside temperature, charging, driving load.
- 04Cooling-system or module diagnosis is Tesla Service work — the pack is sealed high-voltage hardware.
EV systems involved in bms_w102_hw_bmb_thermal_shutdown
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Driver assistance sensors & compute
Cameras, radar (on equipped cars), ultrasonic sensors, and the computer that fuses them into Autopilot/FSD and safety features. These systems degrade gracefully: they remove convenience features rather than touching steering, brakes or throttle.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
Thermal management (cooling loop)
Pumps, valves, fans and coolant loops that keep the battery, motors, power electronics and cabin in their happy temperature bands. An EV derates power and charging speed long before anything overheats, so most thermal codes are about prevention, not damage.
Severity
Stop driving and let it cool. If the warning returns after cooling, tow to service — battery overtemperature is not a wait-and-see problem.
Estimated repair cost
Dealer / service center
— – —
Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_f033_sw_crashBattery Management System: Crash Event Detected (Pyro Fuse Blown)
- bms_f129_sw_bmb_vsh_connectorBattery Management System: Voltage Sense Harness (VSH) Connector High Resistance
- bms_u018_soc_imbalance_limitingBattery Management System — Maximum Charge Limited by Cell Imbalance
- bms_w065_sw_brick_low_capacityBattery Management System — One Cell Group Has Lost Too Much Capacity