bms_w170_sw_module_overvoltage
Do not driveTesla · BMS system
Battery Management System — Module Voltage Too High
What it means
A module voltage sensor inside the battery pack reported a voltage above the allowed maximum. The BMS treats this as a charging safety issue and blocks charging until every module sensor reads back in range. Over-voltage at the module level can mean a sensing problem or a real over-charged section of the pack.
Symptoms
- "Unable to charge — Service required" message
- Charging refuses to start or stops immediately
- Warning chime when the alert sets
- Car may still drive but cannot be recharged
Likely causes (by probability)
- 1.Faulty module voltage sensor or sense wiring inside the packMedium
- 2.Severe cell imbalance pushing one module above the limit at high SOCMedium
- 3.Charging equipment delivering abnormal voltage (less common, rules itself out when unplugged)Low
What you can check yourself
- 01Unplug from the charger and retry once — note whether the alert clears
- 02With Scan My Tesla, check individual brick voltages for one group sitting far above the others
- 03Note the state of charge when the alert set (over-voltage often appears near 100% SOC)
- 04Do NOT attempt to open the pack or bypass the BMS — schedule Tesla Service instead
EV systems involved in bms_w170_sw_module_overvoltage
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Driver assistance sensors & compute
Cameras, radar (on equipped cars), ultrasonic sensors, and the computer that fuses them into Autopilot/FSD and safety features. These systems degrade gracefully: they remove convenience features rather than touching steering, brakes or throttle.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
Severity
You can drive on remaining charge, but you cannot recharge until this is fixed — head toward service rather than running the pack down.
Estimated repair cost
Dealer / service center
— – —
Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_a071_sw_sm_transcon_not_metBattery Management System — State Change Blocked
- bms_a156_sw_bmb_vref_badBattery Management System — Cell Monitor Reference Voltage Out of Range
- bms_f038_sw_neg_contactorBattery Management System: Negative Contactor Fault
- bms_f139_sw_dc_link_v_irrationalBattery Management System: DC Link Voltage Sensor Irrational