bms_f038_sw_neg_contactor
Do not driveTesla · BMS system
Battery Management System: Negative Contactor Fault
What it means
The mirror of the positive-side fault: the BMS commanded the negative main contactor closed but confirmed it did not close within the expected window. The negative contactor completes the high-voltage circuit, so the pack stays disconnected and the car cannot power its high-voltage systems.
Symptoms
- "Unable to start vehicle / Service required" message
- No drive, no charging, no low-voltage support from the pack
- Startup sequence aborts partway through
Likely causes (by probability)
- 1.Negative contactor stuck, worn, or weldedMedium
- 2.Contactor coil driver or wiring faultMedium
- 3.Weak 12V supply unable to hold the contactor closedLow
What you can check yourself
- 01Do one full power-down and single retry only — repeated attempts can overheat the precharge circuit
- 02Check companion alerts like bms_f153 (welded negative) or bms_f062 (contactor power supply)
- 03Check 12V battery health with an OBD app before assuming the worst
- 04No owner-level fix exists — the contactors are sealed inside the battery pack
EV systems involved in bms_f038_sw_neg_contactor
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
High-voltage distribution & safety
Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.
Severity
Not drivable. Limit restart attempts and arrange a tow to Tesla Service for contactor diagnosis.
Estimated repair cost
Dealer / service center
— – —
Contactor replacement is pack-internal work, covered under battery warranty in many cases — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_f110_sw_module_vsenseBattery Management System: Module Voltage Sensing Mismatch
- bms_u011_fast_charger_problemBattery Management System — DC Fast Charging / Supercharging Blocked
- bms_w056_sw_module_temp_outlierBattery Management System — One Module Reporting an Odd Temperature (Log)
- bms_w160_sw_brick_overchargedBattery Management System — Cell Group Overcharged (Early Flag)