cp_a006_lostcommsbms
Do not driveTesla · CP system
Charge Port — Lost Communication With the BMS
What it means
The charge port controller is not receiving the CAN messages it expects from the Battery Management System. Because charging is a conversation between the charge port and the BMS, a broken link means the car may refuse to charge at all until communication comes back.
Symptoms
- "Unable to charge — Service required" message
- Charging will not start on AC or DC
- Warning chime when plugging in
- Charge port light may behave abnormally
Likely causes (by probability)
- 1.Wiring or connector fault between the charge port ECU and the BMSMedium
- 2.BMS software crash or a module stuck after an updateMedium
- 3.Charge port ECU hardware failureLow
What you can check yourself
- 01Unplug, lock the car, and let it sleep for 30 minutes, then try charging again
- 02Try a different charger (home vs. public) to rule out equipment issues
- 03Check for other BMS communication alerts active at the same time
- 04Install any pending software update before assuming hardware failure
EV systems involved in cp_a006_lostcommsbms
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Body domain controllers
Distributed controllers around the car (front, left, right, doors, seats, charge port) that run lights, latches, wipers, windows and actuators, and report state back over the vehicle network. A mismatch between what a latch says and what the network sees is a classic body-domain fault.
Deep dive: what owners should know
Of all the communication-fault permutations in the charging system, CP_A006 is the one that most directly blocks your next charge, because the charge port and the BMS hold a continuous conversation during every session — the port reports cable state, lock status and pilot signals, while the BMS sets the limits the session must respect — and this code means that conversation has gone silent. The charging stack handles the silence conservatively: sessions that are running may continue on last-known parameters for safety's sake, but new sessions will not start, because beginning a charge without BMS oversight is precisely the scenario the whole architecture exists to prevent. The silence itself has the usual three suspects, in the usual order. First: a reboot — of the charge port controller, the BMS, or both — briefly severs the link and logs the gap; these cases clear on the next drive-and-charge cycle and never return. Second: the wiring between port and BMS, a dedicated communication path that lives in the harsh environment behind the charge port, exposed to water, salt, and the mechanical flexing of cable handling; corroded pins here produce exactly the recurring, weather-sensitive version of this code. Third: either endpoint genuinely failing — the port's electronics, or the BMS-side interface — which converts intermittent silence into permanent silence and ends with hardware replacement. The owner triage is short and free: note whether the code appeared once and vanished (reboot) or returns with every charging attempt (infrastructure or hardware); inspect the port for the water-and-corrosion story; and try a session after a full car sleep cycle to give both endpoints a clean restart. A persistent version of this code strands your charging capability, so persistent versions earn prompt service appointments.
Severity
If the car cannot charge, treat your remaining range as all you have — head to service before the pack runs low.
Estimated repair cost
Dealer / service center
— – —
Usually a communication or charge-port repair rather than a battery issue; cost varies by warranty status — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.