All codes

dir_a059_heatsinkot

Drive with caution

Tesla · DIR system

Rear Drive Inverter — Heatsink Overtemperature

What it means

The rear drive inverter is reporting that its heatsink is hotter than the allowed limit. The inverter cools its power electronics through that heatsink, so a sustained overheat can permanently damage it. The car warns you loudly because continuing to push the car could cook the drive unit.

Symptoms

  • "Motor overheating — Pull over now" message
  • Repeating critical chime with a red motor temperature icon
  • Noticeably reduced power before the alert, especially after hard driving
  • More likely after track use, towing, mountain driving, or in hot weather

Likely causes (by probability)

  1. 1.Sustained high-power driving overwhelming the cooling systemHigh
  2. 2.Low coolant level or a coolant pump/valve fault in the drive-unit cooling loopMedium
  3. 3.Failing temperature sensor reading higher than realityLow

What you can check yourself

  • 01Pull over, shift to Park, and let the car idle-cool for 20–30 minutes before driving gently again
  • 02Avoid hard acceleration until the alert stays clear
  • 03Check for related thermal alerts (coolant pump, fan, or VCFRONT alerts) that explain the poor cooling
  • 04Do NOT open any coolant or inverter hardware while hot — just let it cool and book service if it repeats

EV systems involved in dir_a059_heatsinkot

Drive unit (motor + inverter)

The inverter switches battery DC into the variable AC that spins the motor, and the resolver (position sensor) tells it exactly where the rotor is. Torque control is only as good as that position feedback and the inverter's thermal headroom.

Driver assistance sensors & compute

Cameras, radar (on equipped cars), ultrasonic sensors, and the computer that fuses them into Autopilot/FSD and safety features. These systems degrade gracefully: they remove convenience features rather than touching steering, brakes or throttle.

Thermal management (cooling loop)

Pumps, valves, fans and coolant loops that keep the battery, motors, power electronics and cabin in their happy temperature bands. An EV derates power and charging speed long before anything overheats, so most thermal codes are about prevention, not damage.

Vehicle network (CAN / gateway)

Multiple CAN buses link every controller; the gateway routes messages between them and to diagnostics. "MIA" (missing in action) alerts almost always mean a node stopped sending on its bus — the cause can be the node itself, its wiring, or its power supply.

Severity

Drive with caution

Pull over and let the drive unit cool down. If the alert returns during normal driving, the cooling system needs service — do not keep heat-cycling the inverter.

Estimated repair cost

Dealer / service center

— – —

Could be as simple as coolant service or as involved as a drive unit; cost varies — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site