direl_a092_bmsmia
Drive with cautionTesla · DIREL system
Rear Drive Inverter — BMS Communication Lost
What it means
The rear drive unit inverter is not hearing from the Battery Management System on the CAN bus. The rear inverter needs BMS data for pack limits and status, so it flags the BMS as missing in action. On single-motor cars this affects your only source of propulsion.
Symptoms
- No direct customer message at this level
- Rear motor power may be limited by related alerts
- Silent alert on the center display
- Possible reduced acceleration or a follow-up "power reduced" message
Likely causes (by probability)
- 1.CAN wiring or connector fault between the rear inverter and the BMSMedium
- 2.Module crash cleared by a full vehicle sleep cycleMedium
- 3.Software version mismatch after an incomplete updateLow
What you can check yourself
- 01Let the car sleep fully (locked, untouched, 30+ minutes) and recheck the alert
- 02Install any pending software update
- 03Look for other MIA alerts set at the same time — a cluster of them suggests a bus or power issue
- 04Note whether power feels reduced and mention it when booking service
EV systems involved in direl_a092_bmsmia
Drive unit (motor + inverter)
The inverter switches battery DC into the variable AC that spins the motor, and the resolver (position sensor) tells it exactly where the rotor is. Torque control is only as good as that position feedback and the inverter's thermal headroom.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Vehicle network (CAN / gateway)
Multiple CAN buses link every controller; the gateway routes messages between them and to diagnostics. "MIA" (missing in action) alerts almost always mean a node stopped sending on its bus — the cause can be the node itself, its wiring, or its power supply.
Severity
Drive gently and avoid relying on full power until it is resolved. If the car limits power or the alert keeps returning, schedule service soon.
Estimated repair cost
Dealer / service center
— – —
Usually a communication or inverter issue, not a battery replacement; cost varies by warranty status — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- dif_a092_bmsmiaFront Drive Inverter — BMS Communication Lost
- bms_a166_sw_pack_full_weldBattery Management System — Both Pack Contactors Welded
- bms_f052_sw_charger_miaBattery Management System: Onboard Charger Not Responding (MIA)
- bms_f146_sw_brick_overdischargedBattery Management System: Brick Overdischarged