bms_f052_sw_charger_mia
Do not driveTesla · BMS system
Battery Management System: Onboard Charger Not Responding (MIA)
What it means
The BMS cannot talk to the onboard charger — the module that converts AC power from a wall connector into DC for the battery. Without communication, AC charging is disabled. DC fast charging may still work because it bypasses the onboard charger.
Symptoms
- AC charging (home/destination charging) does not work
- Supercharging may still function normally
- No customer-facing text in many cases — found in logs
Likely causes (by probability)
- 1.Onboard charger module failureMedium
- 2.CAN communication wiring fault between BMS and chargerMedium
- 3.Charger power supply or connector issueLow
What you can check yourself
- 01Test a Supercharger session — if DC fast charging works, the onboard charger is the prime suspect
- 02Try a different AC charger/cable to rule out the wall unit before blaming the car
- 03Power-cycle the car fully and retry charging once
- 04Check for companion charging alerts (bms_f074, bms_f077) to give service the full picture
EV systems involved in bms_f052_sw_charger_mia
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
Vehicle network (CAN / gateway)
Multiple CAN buses link every controller; the gateway routes messages between them and to diagnostics. "MIA" (missing in action) alerts almost always mean a node stopped sending on its bus — the cause can be the node itself, its wiring, or its power supply.
Severity
The car cannot take AC charge, so plan around it — use Supercharging if available and schedule service soon.
Estimated repair cost
Dealer / service center
— – —
Onboard charger replacement is a common repair; covered under battery warranty in many cases — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_f139_sw_dc_link_v_irrationalBattery Management System: DC Link Voltage Sensor Irrational
- bms_u025_brick_voltage_limitBattery Management System — Maximum Cell Voltage Lowered Due to Pack Wear
- bms_w070_sw_iso_fast_floodBattery Management System — Sudden Loss of Isolation While Driving
- bms_w170_sw_module_overvoltageBattery Management System — Module Voltage Too High