All codes

fc_a132_ca_bmsmia

Drive with caution

Tesla · FC system

Fast Charge Controller — CHAdeMO Blocked, BMS Not Responding

What it means

The fast-charge controller cannot see the Battery Management System on the CAN bus, so CHAdeMO DC fast charging is disabled. The handshake between the charger and the car depends on that BMS link; without it, the session will not start. Regular AC charging and driving are typically unaffected.

Symptoms

  • "Unable to DC fast charge" message
  • Instruction to contact the charging station operator
  • CHAdeMO sessions fail to start
  • AC charging and normal driving still work

Likely causes (by probability)

  1. 1.CAN communication fault between the fast-charge ECU and the BMSMedium
  2. 2.Problem at the specific charging station (try another one)Medium
  3. 3.Faulty CHAdeMO adapterLow
  4. 4.Software glitch cleared by an update or sleep cycleLow

What you can check yourself

  • 01Try a different charging station before assuming the car is at fault
  • 02If you use a CHAdeMO adapter, reseat it and check its pins for damage
  • 03Unplug, lock the car, let it sleep 30 minutes, and retry
  • 04Install pending software updates and check for other BMS comms alerts

EV systems involved in fc_a132_ca_bmsmia

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Body domain controllers

Distributed controllers around the car (front, left, right, doors, seats, charge port) that run lights, latches, wipers, windows and actuators, and report state back over the vehicle network. A mismatch between what a latch says and what the network sees is a classic body-domain fault.

Vehicle network (CAN / gateway)

Multiple CAN buses link every controller; the gateway routes messages between them and to diagnostics. "MIA" (missing in action) alerts almost always mean a node stopped sending on its bus — the cause can be the node itself, its wiring, or its power supply.

Severity

Drive with caution

You can drive and AC charge normally — only DC fast charging via CHAdeMO is down. Try another station first; if it follows the car, book service.

Estimated repair cost

Dealer / service center

— – —

Often a software or communication fix; varies by warranty status — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site