All codes

fc_a140_ca_bmsincompatible

Drive with caution

Tesla · FC system

Fast Charge Controller — CHAdeMO Blocked, BMS Protocol Mismatch

What it means

During the CHAdeMO handshake, the fast-charge controller found that the BMS is speaking a protocol version the charger cannot work with. The car blocks the DC fast-charge session to be safe. This is usually resolved by a vehicle software update rather than hardware.

Symptoms

  • "Unable to charge with CHAdeMO adapter" message
  • "Vehicle software update required" instruction
  • CHAdeMO session refuses to start
  • AC charging and driving unaffected

Likely causes (by probability)

  1. 1.Out-of-date vehicle or BMS firmware that predates the charger's protocolHigh
  2. 2.Very old CHAdeMO station firmware (try a different station)Medium
  3. 3.Incomplete software update leaving mixed versionsLow

What you can check yourself

  • 01Check for and install any pending vehicle software update — that is the most likely fix
  • 02Try a different CHAdeMO station to rule out a quirky charger
  • 03If using an adapter, confirm it is fully seated
  • 04If no update is available and multiple stations fail, schedule service

EV systems involved in fc_a140_ca_bmsincompatible

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Body domain controllers

Distributed controllers around the car (front, left, right, doors, seats, charge port) that run lights, latches, wipers, windows and actuators, and report state back over the vehicle network. A mismatch between what a latch says and what the network sees is a classic body-domain fault.

Vehicle network (CAN / gateway)

Multiple CAN buses link every controller; the gateway routes messages between them and to diagnostics. "MIA" (missing in action) alerts almost always mean a node stopped sending on its bus — the cause can be the node itself, its wiring, or its power supply.

Severity

Drive with caution

Only CHAdeMO fast charging is affected. Update the car's software first — in most cases that resolves it without a service visit.

Estimated repair cost

Dealer / service center

— – —

Usually resolved with a software update at no cost; otherwise varies by warranty status — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site