All codes

fc_w265_gb_bmsincompatible

Drive with caution

Tesla · FC system

Fast Charge Controller — GB/T DC Charging Blocked, Protocol Mismatch (S/X)

What it means

On Model S/X, the GB/T (Chinese standard) fast-charge handshake failed because the BMS protocol version does not match what the charging equipment expects. The session is blocked and the car reports it as an adapter fault.

Symptoms

  • "Charge adapter fault — Unplug and retry" message
  • GB/T DC fast charging will not start
  • AC charging and driving unaffected
  • Warning chime when the session fails

Likely causes (by probability)

  1. 1.Outdated vehicle/BMS firmwareHigh
  2. 2.Station firmware quirk (try another station)Medium
  3. 3.Incomplete software updateLow

What you can check yourself

  • 01Install pending vehicle software updates first
  • 02Unplug, reseat the adapter, and retry
  • 03Try a different GB/T station
  • 04If it persists at multiple stations after updating, schedule service

EV systems involved in fc_w265_gb_bmsincompatible

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Body domain controllers

Distributed controllers around the car (front, left, right, doors, seats, charge port) that run lights, latches, wipers, windows and actuators, and report state back over the vehicle network. A mismatch between what a latch says and what the network sees is a classic body-domain fault.

Vehicle network (CAN / gateway)

Multiple CAN buses link every controller; the gateway routes messages between them and to diagnostics. "MIA" (missing in action) alerts almost always mean a node stopped sending on its bus — the cause can be the node itself, its wiring, or its power supply.

Severity

Drive with caution

Only GB/T fast charging is affected. Software update plus a different station resolves most cases.

Estimated repair cost

Dealer / service center

— – —

Usually resolved with a software update at no cost; otherwise varies by warranty status — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site