All codes

fc_w132_ca_bmsmia

Drive with caution

Tesla · FC system

Fast Charge Controller — CHAdeMO Blocked, BMS Not Responding (S/X)

What it means

On Model S/X, the fast-charge controller has lost the BMS on the CAN bus and is blocking CHAdeMO DC fast charging. The session cannot start because the charger handshake depends on live BMS data. AC charging and driving are normally unaffected.

Symptoms

  • "Unable to DC fast charge" message
  • Instruction to contact the charging station operator
  • CHAdeMO sessions fail to start
  • Warning chime when the session fails

Likely causes (by probability)

  1. 1.CAN communication fault between the fast-charge ECU and BMSMedium
  2. 2.Station-side problem (try another charger)Medium
  3. 3.Faulty CHAdeMO adapterLow
  4. 4.Software glitch cleared by update or sleep cycleLow

What you can check yourself

  • 01Try another CHAdeMO station first
  • 02Reseat the CHAdeMO adapter and inspect its connector pins
  • 03Full sleep cycle (locked, 30+ minutes), then retry
  • 04Install pending updates and check for other BMS comms alerts

EV systems involved in fc_w132_ca_bmsmia

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Body domain controllers

Distributed controllers around the car (front, left, right, doors, seats, charge port) that run lights, latches, wipers, windows and actuators, and report state back over the vehicle network. A mismatch between what a latch says and what the network sees is a classic body-domain fault.

Vehicle network (CAN / gateway)

Multiple CAN buses link every controller; the gateway routes messages between them and to diagnostics. "MIA" (missing in action) alerts almost always mean a node stopped sending on its bus — the cause can be the node itself, its wiring, or its power supply.

Severity

Drive with caution

You can drive and AC charge — only CHAdeMO fast charging is down. Rule out the station and adapter before scheduling service.

Estimated repair cost

Dealer / service center

— – —

Often a software or communication fix; varies by warranty status — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site