All codes

fc_a265_gb_bmsincompatible

Drive with caution

Tesla · FC system

Fast Charge Controller — GB/T DC Charging Blocked, Protocol Mismatch

What it means

During the GB/T handshake, the fast-charge controller found the BMS protocol version incompatible with the charging equipment. The session is blocked before it starts. Like the CHAdeMO version of this alert, software is usually the cure.

Symptoms

  • "Charge adapter fault — Unplug and retry" message
  • GB/T DC fast charging will not start
  • AC charging and driving unaffected
  • Warning chime when the session fails

Likely causes (by probability)

  1. 1.Outdated vehicle/BMS firmware versus the station's protocol versionHigh
  2. 2.Station-side firmware quirk (try another station)Medium
  3. 3.Incomplete software updateLow

What you can check yourself

  • 01Install any pending vehicle software update first
  • 02Unplug, reseat the adapter, and retry
  • 03Try a different GB/T charging station
  • 04If it fails at multiple stations after updating, schedule service

EV systems involved in fc_a265_gb_bmsincompatible

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Body domain controllers

Distributed controllers around the car (front, left, right, doors, seats, charge port) that run lights, latches, wipers, windows and actuators, and report state back over the vehicle network. A mismatch between what a latch says and what the network sees is a classic body-domain fault.

Vehicle network (CAN / gateway)

Multiple CAN buses link every controller; the gateway routes messages between them and to diagnostics. "MIA" (missing in action) alerts almost always mean a node stopped sending on its bus — the cause can be the node itself, its wiring, or its power supply.

Severity

Drive with caution

Only GB/T DC fast charging is affected. Update the software and try another station; most cases never need a service visit.

Estimated repair cost

Dealer / service center

— – —

Usually resolved with a software update at no cost; otherwise varies by warranty status — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site