All codes

fc_w142_ca_evseconn_ot

Drive with caution

Tesla · FC system

Fast Charge Controller — CHAdeMO Connector Overheating

What it means

The fast-charge controller detected that the charging connector on the CHAdeMO station side is running hotter than it should. The car blocks DC fast charging to protect the connector and your charge port. Heat at the connector usually points to worn contacts at the station or a poor connection.

Symptoms

  • "Charge adapter temperature high" message
  • "DC fast charging / Supercharging unavailable" warning
  • CHAdeMO session stops or refuses to start
  • Connector or adapter may feel warm to the touch

Likely causes (by probability)

  1. 1.Worn or dirty contacts at the charging station connectorHigh
  2. 2.Poorly seated CHAdeMO adapter creating resistance and heatMedium
  3. 3.Very high ambient temperature combined with a long fast-charge sessionLow

What you can check yourself

  • 01Stop the session and let the connector cool before touching or retrying
  • 02Reseat the adapter firmly and try a different station
  • 03Inspect the adapter and port for dirt, corrosion, or melted-looking spots — if you see damage, stop using it
  • 04Retry later at a cooler time of day; repeated overheating at multiple stations means service

EV systems involved in fc_w142_ca_evseconn_ot

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

Thermal management (cooling loop)

Pumps, valves, fans and coolant loops that keep the battery, motors, power electronics and cabin in their happy temperature bands. An EV derates power and charging speed long before anything overheats, so most thermal codes are about prevention, not damage.

Body domain controllers

Distributed controllers around the car (front, left, right, doors, seats, charge port) that run lights, latches, wipers, windows and actuators, and report state back over the vehicle network. A mismatch between what a latch says and what the network sees is a classic body-domain fault.

Vehicle network (CAN / gateway)

Multiple CAN buses link every controller; the gateway routes messages between them and to diagnostics. "MIA" (missing in action) alerts almost always mean a node stopped sending on its bus — the cause can be the node itself, its wiring, or its power supply.

Severity

Drive with caution

Do not force repeated sessions into a hot connector — that is how charge ports get damaged. Try another station; if it overheats everywhere, book service.

Estimated repair cost

Dealer / service center

— – —

If the car-side port or adapter is damaged, cost varies by warranty status — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site