hvp_w027_bmsmiaonhvsfault
Drive with cautionTesla · HVP system
High-Voltage Controller — BMS Missing on the HVS CAN Bus
What it means
Same problem as the HVI variant, but on the HVS CAN bus: the high-voltage controller is not receiving BMS messages on that network. Depending on which bus carries which messages, charging or drive functions can be limited by related alerts.
Symptoms
- No customer-facing message in most cases
- Silent alert on the center display
- Possible charging limitations through companion alerts
- May appear with other bus communication faults
Likely causes (by probability)
- 1.Wiring or connector fault on the HVS CAN busMedium
- 2.BMS offline or crashedMedium
- 3.Low-voltage supply issues destabilizing the busLow
What you can check yourself
- 01Let the car sleep fully for 30+ minutes and recheck
- 02Install pending software updates
- 03Check for other MIA alerts — widespread MIA points to the BMS or power, not one wire
- 04If persistent or paired with charging problems, schedule service
EV systems involved in hvp_w027_bmsmiaonhvsfault
High-voltage distribution & safety
Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Low-voltage (12V/16V) system
The small battery and DC-DC converter that power every computer, relay, contactor coil and sensor in the car. EVs are famously sensitive to a weak low-voltage battery — it causes cascading "ghost" faults across unrelated systems.
Severity
Usually benign after a sleep cycle, but persistent bus faults deserve a service visit before they affect charging or drive.
Estimated repair cost
Dealer / service center
— – —
Usually a communication or software fix; covered under battery/powertrain warranty in many cases — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- hvp_w014_bmsmiaonhvifaultHigh-Voltage Controller — BMS Missing on the HVI CAN Bus
- hvp_w032_shunthwandbmsmiafaultHigh-Voltage Controller — BMS and Current Shunt Both Offline, Pyro Fuse Will Blow
- hvp_w012_bmbdataintegritylossHigh-Voltage Controller — Battery Monitoring Data Integrity Lost
- bms_a059_sw_pack_voltage_sensingBattery Management System — Pack Voltage Reading Mismatch