hvp_w014_bmsmiaonhvifault
Drive with cautionTesla · HVP system
High-Voltage Controller — BMS Missing on the HVI CAN Bus
What it means
The high-voltage powertrain controller cannot find the BMS on the HVI CAN bus — the network the high-voltage components use to talk to each other. Messages from the BMS and possibly other nodes on that bus are not arriving.
Symptoms
- No customer-facing message in most cases
- Silent alert on the center display
- Possible charging or drive limitations via related alerts
- Often appears with other HVI bus communication faults
Likely causes (by probability)
- 1.Wiring or connector fault on the HVI CAN busMedium
- 2.BMS crashed or offlineMedium
- 3.Weak low-voltage supply causing bus instabilityLow
What you can check yourself
- 01Full sleep cycle (locked, 30+ minutes) and see if communication recovers
- 02Install pending software updates
- 03Check for other HVI or BMS MIA alerts to judge whether the bus or the BMS is at fault
- 04If it persists, schedule service and mention all related alerts
EV systems involved in hvp_w014_bmsmiaonhvifault
High-voltage distribution & safety
Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.
Braking & stability control
Friction brakes blended with regenerative braking, ABS/stability electronics, and wheel-speed sensors. Because regen does most slowing in an EV, brake hardware sees less wear — but its sensors and software are still safety-critical.
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Low-voltage (12V/16V) system
The small battery and DC-DC converter that power every computer, relay, contactor coil and sensor in the car. EVs are famously sensitive to a weak low-voltage battery — it causes cascading "ghost" faults across unrelated systems.
Severity
Often resolves with a sleep cycle or update. If it keeps coming back or charging/driving is affected, get the bus checked by service.
Estimated repair cost
Dealer / service center
— – —
Usually a communication or software fix; covered under battery/powertrain warranty in many cases — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- hvp_w027_bmsmiaonhvsfaultHigh-Voltage Controller — BMS Missing on the HVS CAN Bus
- hvp_w032_shunthwandbmsmiafaultHigh-Voltage Controller — BMS and Current Shunt Both Offline, Pyro Fuse Will Blow
- hvp_w012_bmbdataintegritylossHigh-Voltage Controller — Battery Monitoring Data Integrity Lost
- bms_f017_sw_brick_ovBattery Management System: Brick Overvoltage