aps_w130_ecu_thermal_issue
Drive with cautionTesla · APS system
Autopilot — Computer Overtemperature Warning
What it means
The Autopilot computer board got hotter than its safe operating limit, so the car logged this warning. To protect itself, the system can shut Autopilot down until temperatures come back to normal. Think of it like a laptop thermal-throttling or powering off on a hot day.
Symptoms
- Autopilot and Full Self-Driving features suddenly unavailable
- Alert appears during or after hot weather, heavy Autopilot use, or direct sun on the dash
- Features may return once the cabin and electronics cool down
- No impact on basic driving, steering, or braking
Likely causes (by probability)
- 1.Extreme cabin or electronics-bay temperatures (heat soak while parked in the sun)High
- 2.Blocked or failed cooling for the Autopilot computerMedium
- 3.Sustained heavy compute load on a hot dayMedium
- 4.Failing thermal sensor or Autopilot board hardwareLow
What you can check yourself
- 01Note the conditions when it happened — parked in the sun, long Autopilot session, high ambient temperature.
- 02Precondition the cabin before driving on hot days and see whether the alert stops recurring.
- 03Check for a pattern: if it only appears on very hot days, it is more likely environmental than a hardware fault.
- 04Keep software up to date — Tesla has adjusted thermal management behavior via updates.
EV systems involved in aps_w130_ecu_thermal_issue
Driver assistance sensors & compute
Cameras, radar (on equipped cars), ultrasonic sensors, and the computer that fuses them into Autopilot/FSD and safety features. These systems degrade gracefully: they remove convenience features rather than touching steering, brakes or throttle.
Steering system
Electric power steering rack, torque and angle sensors. Assist faults preserve manual control (the wheel stays mechanically connected) but every assist system disengages as a precaution.
Thermal management (cooling loop)
Pumps, valves, fans and coolant loops that keep the battery, motors, power electronics and cabin in their happy temperature bands. An EV derates power and charging speed long before anything overheats, so most thermal codes are about prevention, not damage.
Vehicle network (CAN / gateway)
Multiple CAN buses link every controller; the gateway routes messages between them and to diagnostics. "MIA" (missing in action) alerts almost always mean a node stopped sending on its bus — the cause can be the node itself, its wiring, or its power supply.
Severity
Safe to drive — only driver-assist features drop out. If the alert appears in mild weather, have the Autopilot computer cooling checked.
Estimated repair cost
Dealer / service center
— – —
Typically covered under the basic vehicle warranty if hardware is at fault; out-of-warranty cost varies — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- aps_w169_turboa_scs_lkupAutopilot — Main Processor Lockup and Restart
- bms_w036_sw_hvilBattery Management System — High-Voltage Interlock Loop (HVIL) Problem
- bms_w141_sw_12v_pwr_supply_lowBattery Management System — Low-Voltage (12V) Supply Too Low
- fc_w132_ca_bmsmiaFast Charge Controller — CHAdeMO Blocked, BMS Not Responding (S/X)