aps_w169_turboa_scs_lkup
Drive with cautionTesla · APS system
Autopilot — Main Processor Lockup and Restart
What it means
The main processor inside the Autopilot computer hit a lockup error in its safety controller subsystem, which forced the whole Autopilot unit to reboot. While it is restarting, every Autopilot feature goes offline. This is a self-protection reset, similar to a phone freezing and rebooting itself.
Symptoms
- All Autopilot / FSD features unavailable, sometimes mid-drive
- Alert appears on the center display without a chime
- Features usually come back after the computer finishes restarting
- Normal steering, braking, and acceleration are unaffected
Likely causes (by probability)
- 1.Software crash or race condition in the Autopilot firmwareHigh
- 2.Memory or processor fault developing on the Autopilot boardMedium
- 3.Power supply fluctuation to the Autopilot computerLow
- 4.Hardware failure requiring computer replacementLow
What you can check yourself
- 01Note the date, time, and what you were doing when the alert appeared — service can pull logs for that window.
- 02Check whether it was a one-time event or repeats; a single lockup after an update is usually benign.
- 03Install any pending software update — lockup bugs are frequently fixed in firmware.
- 04If it recurs, capture a short video of the alert and any behavior change for the service visit.
EV systems involved in aps_w169_turboa_scs_lkup
Driver assistance sensors & compute
Cameras, radar (on equipped cars), ultrasonic sensors, and the computer that fuses them into Autopilot/FSD and safety features. These systems degrade gracefully: they remove convenience features rather than touching steering, brakes or throttle.
Steering system
Electric power steering rack, torque and angle sensors. Assist faults preserve manual control (the wheel stays mechanically connected) but every assist system disengages as a precaution.
Drive unit (motor + inverter)
The inverter switches battery DC into the variable AC that spins the motor, and the resolver (position sensor) tells it exactly where the rotor is. Torque control is only as good as that position feedback and the inverter's thermal headroom.
Vehicle network (CAN / gateway)
Multiple CAN buses link every controller; the gateway routes messages between them and to diagnostics. "MIA" (missing in action) alerts almost always mean a node stopped sending on its bus — the cause can be the node itself, its wiring, or its power supply.
Severity
You can keep driving without Autopilot. Recurring lockups mean the Autopilot computer needs a service look before the problem becomes permanent.
Estimated repair cost
Dealer / service center
— – —
Autopilot computer issues are typically covered under the basic vehicle warranty; out-of-warranty replacement is expensive — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- aps_w130_ecu_thermal_issueAutopilot — Computer Overtemperature Warning
- bms_a169_sw_fc_pack_weldBattery Management System — One Pack and One Fast-Charge Contactor Welded
- bms_f059_sw_pack_voltage_sensingBattery Management System: Pack Voltage Sensing Mismatch
- bms_f152_sw_pos_contactor_weldedBattery Management System: Positive Contactor Welded