All codes

bms_w036_sw_hvil

Do not drive

Tesla · BMS system

Battery Management System — High-Voltage Interlock Loop (HVIL) Problem

What it means

The HVIL is a low-voltage safety loop wired through every high-voltage connector in the car — if any connector is loose, damaged, or unplugged, the loop breaks and the car knows a high-voltage connection is compromised. The BMS detected the loop voltage outside its expected range, so the high-voltage system stays off: no driving, no charging.

Symptoms

  • Car won't start or drive
  • Unable to charge
  • May appear after recent service work, a collision, or water exposure
  • Sometimes intermittent — car works, then refuses to start

Likely causes (by probability)

  1. 1.A high-voltage connector not fully seated or its locking tab damagedHigh
  2. 2.Damaged interlock wiring (collision, rodents, chafing)Medium
  3. 3.Corrosion or moisture in a connectorMedium
  4. 4.A faulty interlock circuit on the BMS sideLow

What you can check yourself

  • 01Think about any recent service, repairs, or impacts — a connector left slightly unseated is a classic cause.
  • 02Check for rodent damage or water intrusion in areas you can see without disassembly.
  • 03Note if the fault is intermittent and what seems to trigger it.
  • 04Never unplug or reseat high-voltage (orange) connectors yourself — lethal voltage; this is Tesla Service work.

EV systems involved in bms_w036_sw_hvil

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

High-voltage battery pack

The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.

High-voltage distribution & safety

Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.

Severity

Do not drive

The car has lost confirmation that its high-voltage connections are intact. Don't drive — have it inspected and repaired by Tesla Service.

Estimated repair cost

Dealer / service center

— – —

If it's a connector issue after recent service, the responsible shop should fix it. Otherwise often covered under battery warranty; out-of-warranty cost varies — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site