All codes

bms_a003_sw_pack_birth_date_missing

Safe to drive

Tesla · BMS system

Battery Management System — Pack Manufacturing Date Unreadable

What it means

The BMS could not read the battery pack's "birth date" — the manufacturing timestamp stored in its calibration memory. Without it, some long-term battery history statistics cannot accumulate properly. This is a bookkeeping problem inside the BMS, not a physical battery fault.

Symptoms

  • No driver-visible symptoms in most cases
  • Alert may appear silently on the center display without a chime
  • Battery history/usage statistics may be incomplete in service logs
  • Typically only shows up in service-mode or alert logs

Likely causes (by probability)

  1. 1.Calibration data block corrupted or never written at the factoryHigh
  2. 2.BMS or pack replaced and the date was not re-programmedMedium
  3. 3.Software glitch reading the calibration memoryLow

What you can check yourself

  • 01A vehicle restart sometimes lets the BMS re-read the data — park, power off fully, and check again later.
  • 02Check whether the alert clears itself over a few drive cycles.
  • 03Mention it at your next service visit so a technician can reprogram the calibration block.
  • 04No urgent action needed if the car drives and charges normally.

EV systems involved in bms_a003_sw_pack_birth_date_missing

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

High-voltage battery pack

The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

Drive unit (motor + inverter)

The inverter switches battery DC into the variable AC that spins the motor, and the resolver (position sensor) tells it exactly where the rotor is. Torque control is only as good as that position feedback and the inverter's thermal headroom.

Severity

Safe to drive

No immediate action required. Flag it at your next scheduled service so the calibration data can be restored.

Estimated repair cost

Dealer / service center

— – —

Usually a no-charge programming fix during a service visit; covered under battery warranty in many cases.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site