bms_f094_sw_drive_inverter_mia
Drive with cautionTesla · BMS system
Battery Management System: Drive Inverter Not Responding (MIA)
What it means
The BMS is not receiving expected CAN messages from the drive inverter — the unit that turns battery DC power into motor power. Since the BMS cannot confirm the inverter's state, it limits power to be safe. The car usually still drives, but with reduced capability.
Symptoms
- "Reduced power / Service required" message
- Noticeably weaker acceleration
- Possible loss of regen braking
Likely causes (by probability)
- 1.Drive inverter failure or internal faultMedium
- 2.CAN wiring or connector fault between BMS and inverterMedium
- 3.Inverter power supply or ground issueLow
What you can check yourself
- 01Try a full power-down and restart — inverter comm glitches sometimes clear
- 02Note whether power returns after a restart or stays limited
- 03Check for additional drive-unit alerts to distinguish a wiring issue from a dying inverter
- 04Avoid highway driving until resolved — reduced power is a genuine safety limitation
EV systems involved in bms_f094_sw_drive_inverter_mia
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Drive unit (motor + inverter)
The inverter switches battery DC into the variable AC that spins the motor, and the resolver (position sensor) tells it exactly where the rotor is. Torque control is only as good as that position feedback and the inverter's thermal headroom.
Vehicle network (CAN / gateway)
Multiple CAN buses link every controller; the gateway routes messages between them and to diagnostics. "MIA" (missing in action) alerts almost always mean a node stopped sending on its bus — the cause can be the node itself, its wiring, or its power supply.
Severity
Drivable with reduced power, but treat it as limp mode: gentle driving only, straight to service.
Estimated repair cost
Dealer / service center
— – —
Drive-unit work is covered under the drive unit warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_f016_sw_thermal_gradientBattery Management System: Excessive Thermal Gradient Between Modules
- bms_f096_sw_fast_charger_miaBattery Management System: Fast Charger Communication Lost
- bms_u002_ramp_down_activeBattery Management System: Battery Ramp-Down Active
- bms_w037_sw_pos_contactorBattery Management System — Positive Contactor Stuck or Welded