All codes

bms_u001_dischg_while_charging

Drive with caution

Tesla · BMS system

Battery Management System: Discharging While Plugged In

What it means

The car is plugged in, but the battery is not actually gaining charge — the incoming power is too weak, or the pack is busy heating or cooling itself and using the power for that instead. Your range will not increase until conditions improve.

Symptoms

  • "Wall power source insufficient / Charge will not increase" message
  • State of charge flat or slowly dropping while plugged in
  • Common on standard 120V outlets in very cold or hot weather

Likely causes (by probability)

  1. 1.Weak power source (120V outlet, shared circuit, undersized breaker)High
  2. 2.Battery thermal management consuming all incoming power in extreme temperaturesHigh
  3. 3.Charge current set higher than the circuit can sustain, causing throttlingMedium

What you can check yourself

  • 01Lower the charge current in the car's charging settings and see if the battery starts gaining
  • 02Move to a dedicated 240V circuit if you are on a standard outlet — that solves most cases
  • 03In extreme cold, precondition the battery before plugging in so less power goes to heating
  • 04Check that no other heavy load shares the circuit (dryer, heater, another EV)

EV systems involved in bms_u001_dischg_while_charging

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

High-voltage battery pack

The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.

Thermal management (cooling loop)

Pumps, valves, fans and coolant loops that keep the battery, motors, power electronics and cabin in their happy temperature bands. An EV derates power and charging speed long before anything overheats, so most thermal codes are about prevention, not damage.

Severity

Drive with caution

The car is fine — your power source is the limitation. Reduce charge current or find a stronger circuit; no service needed unless it happens on known-good chargers too.

Estimated repair cost

Dealer / service center

— – —

Almost never a car-side repair — this is a charging-infrastructure issue. If it persists on known-good chargers, get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site