bms_a081_sw_ctr_close_blocked
Do not driveTesla · BMS system
Battery Management System — Contactor Close Prevented by Another Alert
What it means
The pack contactors are the heavy-duty relays that connect the battery to the rest of the car. The BMS has refused to close them because another active alert says it is not safe. Until the underlying alert clears, the pack stays disconnected — no driving, no charging, no low-voltage support.
Symptoms
- Car will not drive or charge
- Silent alert accompanying a more specific BMS warning
- Car may power up screens but refuse to go into Drive
- Low-voltage battery drains without pack support
Likely causes (by probability)
- 1.Another BMS alert (isolation, overvoltage, thermal, weld check) actively blocking contactor closureHigh
- 2.Contactor control circuit faultLow
- 3.Software latch-up requiring a full resetLow
What you can check yourself
- 01Identify and read the companion alert first — it holds the real diagnosis.
- 02Try one full sleep cycle; some transient blocking alerts clear on their own.
- 03Do not try to bypass or force the contactors — that interlock exists to protect you and the pack.
- 04If the car is stranded, call Tesla roadside rather than continuing reset attempts.
EV systems involved in bms_a081_sw_ctr_close_blocked
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
High-voltage distribution & safety
Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.
Severity
The car is protecting itself based on another alert. Diagnose the companion alert or have the car towed to service.
Estimated repair cost
Dealer / service center
— – —
Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_w138_sw_brick_ov_warningBattery Management System — Cell Group Voltage Above Warning Threshold
- bms_a049_sw_thermal_eventBattery Management System — Potential Thermal Event Detected
- bms_a142_sw_isolation_degradationBattery Management System — Isolation Degraded (Warning Level)
- bms_f027_sw_drive_iso_repeatedBattery Management System: Repeated Isolation Loss While Driving