bms_w138_sw_brick_ov_warning
Safe to driveTesla · BMS system
Battery Management System — Cell Group Voltage Above Warning Threshold
What it means
One or more cell groups have drifted above a warning-level voltage — below the hard shutdown limit, but high enough for the BMS to log it. Think of it as the yellow flag before the red one: it catches overvoltage trends early, before they become protection shutdowns.
Symptoms
- Usually no immediate symptom — logging-level alert
- May appear near the end of charging sessions
- Can precede harder over-voltage shutdown alerts
Likely causes (by probability)
- 1.A cell group drifting high relative to the pack (imbalance)Medium
- 2.Charging behavior pushing marginal groups over the warning lineMedium
- 3.A voltage-sense error on a monitoring boardLow
What you can check yourself
- 01Note whether it appears at high states of charge — charging to 80–90% instead of 100% may keep it quiet while you investigate.
- 02Check cell voltage spread with Scan My Tesla if available.
- 03If it recurs or escalates to a shutdown alert, schedule service promptly.
EV systems involved in bms_w138_sw_brick_ov_warning
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
Vehicle network (CAN / gateway)
Multiple CAN buses link every controller; the gateway routes messages between them and to diagnostics. "MIA" (missing in action) alerts almost always mean a node stopped sending on its bus — the cause can be the node itself, its wiring, or its power supply.
Severity
An early warning, not a shutdown. Watch charging behavior and escalate to service if it repeats or worsens.
Estimated repair cost
Dealer / service center
— – —
If it progresses to a real over-voltage fault, repairs are covered under battery warranty in many cases — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_a140_hw_bmb_status_faultBattery Management System — Cell Monitor Hardware Fault Flag
- bms_f025_sw_fc_ctrs_open_undr_ldBattery Management System: Fast-Charge Contactors Opened Under Load
- bms_f107_sw_cell_voltage_sensorBattery Management System: Inaccurate Brick Voltage Measurement
- bms_u007_slowed_chg_batt_coldBattery Management System — Charging Slowed Because the Battery Is Cold