All codes

bms_a095_sw_ui_mia

Safe to drive

Tesla · BMS system

Battery Management System — Touchscreen Not Responding

What it means

The BMS has not heard from the touchscreen computer, so it flags the UI as missing. The main real-world effect is that charge-related requests from the screen (start/stop, scheduled charging, charge limit changes) may not reach the BMS. Notably, this alert can appear briefly and harmlessly when the car is first waking from sleep.

Symptoms

  • Charge settings on the screen may not take effect
  • Alert often appears right at wake-up, then clears
  • Screen may be slow, rebooting, or black
  • Silent alert, no chime

Likely causes (by probability)

  1. 1.Normal wake-up timing — the screen boots slower than the BMS expectsHigh
  2. 2.Touchscreen computer rebooting or hangingMedium
  3. 3.Software update in progressLow
  4. 4.Failing media/screen hardwareLow

What you can check yourself

  • 01If it clears within a minute of waking the car, ignore it — that is expected behavior.
  • 02If the screen is frozen, reboot it: hold both steering-wheel scroll buttons until the Tesla logo appears.
  • 03Check that charge limits and schedules actually applied after the alert.
  • 04Persistent alerts plus a flaky screen warrant a service mention.

EV systems involved in bms_a095_sw_ui_mia

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Steering system

Electric power steering rack, torque and angle sensors. Assist faults preserve manual control (the wheel stays mechanically connected) but every assist system disengages as a precaution.

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

Vehicle network (CAN / gateway)

Multiple CAN buses link every controller; the gateway routes messages between them and to diagnostics. "MIA" (missing in action) alerts almost always mean a node stopped sending on its bus — the cause can be the node itself, its wiring, or its power supply.

Severity

Safe to drive

Almost always benign wake-up noise. Only act if the alert persists with a misbehaving screen or charge settings that refuse to stick.

Estimated repair cost

Dealer / service center

— – —

Typically no cost — normal behavior or a software fix; hardware issues are covered under the basic vehicle warranty.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site