All codes

bms_a123_sw_internal_isolation

Do not drive

Tesla · BMS system

Battery Management System — Internal Isolation Fault

What it means

With the pack contactors open, the BMS measured the electrical isolation between the high-voltage system and the car's chassis and found it below the safe minimum — inside the pack itself. Isolation is what keeps high voltage away from the body of the car, so the BMS responds by blocking driving, charging, and low-voltage support.

Symptoms

  • "Unable to charge — Service required" message
  • Car may refuse to drive or come ready
  • Single chime with a warning icon
  • May follow water exposure, collision, or pack service

Likely causes (by probability)

  1. 1.Moisture or coolant intrusion inside the battery packMedium
  2. 2.Damaged high-voltage insulation or wiring inside the packMedium
  3. 3.Failed internal component leaking to chassisMedium
  4. 4.Isolation measurement circuit fault (false reading)Low

What you can check yourself

  • 01Do not attempt to locate the isolation leak yourself — that requires hipot testing by trained technicians.
  • 02Tell service about any flood exposure, deep-water driving, or underbody impacts.
  • 03A full sleep cycle may clear a false reading; a returning alert is a real leak until proven otherwise.
  • 04Avoid charging until cleared — the car blocks it for good reason.

EV systems involved in bms_a123_sw_internal_isolation

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

High-voltage battery pack

The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.

High-voltage distribution & safety

Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.

Severity

Do not drive

Isolation faults are a shock-hazard category. Park it, keep it dry, and let Tesla Service diagnose with proper equipment.

Estimated repair cost

Dealer / service center

— – —

Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site