All codes

bms_a150_sw_missing_part_number

Drive with caution

Tesla · BMS system

Battery Management System — Part Number Missing or Invalid

What it means

The BMS checked the part number stored for its circuit board assembly and found it missing, wrong, or unsupported. That number anchors a lot of board-specific configuration, so without it the BMS cannot fully initialize. Like the other configuration alerts, this points to provisioning gaps after service or data corruption.

Symptoms

  • "Vehicle configuration mismatch — Service required" message
  • Single chime with a warning icon
  • Usually appears after BMS/board replacement or a failed flash
  • Driving and charging may be limited

Likely causes (by probability)

  1. 1.Replacement BMS board not provisioned with its part numberHigh
  2. 2.Corrupted board identity dataMedium
  3. 3.Wrong board variant installed for this vehicleLow

What you can check yourself

  • 01Report any recent BMS or battery service — the alert almost always follows hardware work.
  • 02Check for companion configuration alerts to confirm the provisioning-gap pattern.
  • 03A sleep cycle may clear a transient read error; a persistent alert needs programming.
  • 04No DIY programming — part-number provisioning requires Tesla Toolbox.

EV systems involved in bms_a150_sw_missing_part_number

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

Vehicle network (CAN / gateway)

Multiple CAN buses link every controller; the gateway routes messages between them and to diagnostics. "MIA" (missing in action) alerts almost always mean a node stopped sending on its bus — the cause can be the node itself, its wiring, or its power supply.

Severity

Drive with caution

Service visit needed for re-provisioning. Usually a quick programming job rather than new hardware.

Estimated repair cost

Dealer / service center

— – —

Covered under battery warranty in many cases; typically a programming fix at Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site