All codes

bms_w160_sw_brick_overcharged

Safe to drive

Tesla · BMS system

Battery Management System — Cell Group Overcharged (Early Flag)

What it means

The BMS detected a cell group whose voltage exceeded the maximum threshold and logged it as an early over-voltage flag. It's primarily informational — designed to catch overcharge issues early, before they trigger protective shutdowns or damage cells. If it repeats, the pack wants attention.

Symptoms

  • Usually no immediate symptom — logging alert
  • May appear after charging to 100%
  • Can precede harder over-voltage shutdown alerts

Likely causes (by probability)

  1. 1.A cell group drifting high due to imbalanceMedium
  2. 2.A charging anomaly pushing a marginal group over the lineMedium
  3. 3.Voltage-sense error on a monitoring boardLow

What you can check yourself

  • 01Note the state of charge when it logged — if it clusters at 100%, charge to 80–90% while investigating.
  • 02Check cell voltage spread with Scan My Tesla if available.
  • 03If it recurs, schedule service before it escalates to a shutdown.

EV systems involved in bms_w160_sw_brick_overcharged

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

High-voltage battery pack

The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.

Vehicle network (CAN / gateway)

Multiple CAN buses link every controller; the gateway routes messages between them and to diagnostics. "MIA" (missing in action) alerts almost always mean a node stopped sending on its bus — the cause can be the node itself, its wiring, or its power supply.

Severity

Safe to drive

An early flag rather than a failure. Adjust charging habits, monitor, and escalate to service if it keeps appearing.

Estimated repair cost

Dealer / service center

— – —

If it progresses, repairs are covered under battery warranty in many cases — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site