bms_a165_sw_pack_partial_weld
Drive with cautionTesla · BMS system
Battery Management System — One Pack Contactor Welded
What it means
During its self-test, the BMS detected that one of the two main pack contactors has welded shut — its contacts fused together so it can no longer open on command. The car still runs on the remaining contactor, but a welded contactor means one layer of the pack's emergency disconnect is gone.
Symptoms
- Usually no immediate drivability symptoms
- Silent center-display alert
- Detected during startup self-tests
- May follow a high-current event or contactor wear
Likely causes (by probability)
- 1.Contactor contacts fused by an overcurrent event (short, hard fault current)Medium
- 2.Normal end-of-life wear on the contactorMedium
- 3.Repeated opening under load (pre-charge failure upstream)Medium
- 4.False weld detection from a sense-circuit faultLow
What you can check yourself
- 01Schedule service promptly even though the car drives — a welded contactor is a failed safety device.
- 02Do not attempt contactor service yourself; it is inside the high-voltage enclosure.
- 03Note any recent electrical events (failed starts, burning smell, prior HV alerts).
- 04Avoid situations where you would need the pack to disconnect urgently (it still can, via the second contactor, but redundancy is gone).
EV systems involved in bms_a165_sw_pack_partial_weld
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Body domain controllers
Distributed controllers around the car (front, left, right, doors, seats, charge port) that run lights, latches, wipers, windows and actuators, and report state back over the vehicle network. A mismatch between what a latch says and what the network sees is a classic body-domain fault.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
High-voltage distribution & safety
Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.
Severity
Drivable, but your safety redundancy is halved. Book service soon — contactors are a known service item and usually a straightforward replacement for a technician.
Estimated repair cost
Dealer / service center
— – —
Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_w155_sw_bmb_vref_leakyBattery Management System — Suspect Voltage Reference on a Monitoring Board (Log)
- bms_a068_cac_imbalance_limpBattery Management System — Cell Capacity Imbalance, Limp Mode
- bms_a152_isolation_in_dc_chargeBattery Management System — Low Isolation Detected During DC Charging
- bms_f037_sw_pos_contactorBattery Management System: Positive Contactor Fault