bms_w162_sw_fc_prechg_too_slow
Drive with cautionTesla · BMS system
Battery Management System — Fast-Charge Precharge Too Slow
What it means
When a DC fast-charging session starts, the voltage on the bus should rise at a predictable rate during precharge. The BMS saw it rise too slowly and aborted fast charging. AC charging and normal driving are unaffected. Causes range from the charging station itself to the car's fast-charge path.
Symptoms
- DC fast charging fails to start
- "Disconnect and retry" style message
- AC charging works normally
- Normal driving unaffected
Likely causes (by probability)
- 1.Weak or faulty charging station (low output, bad cable)Medium
- 2.Issue in the car's fast-charge contactor or precharge pathMedium
- 3.Excess load on the bus from another component during prechargeLow
What you can check yourself
- 01Unplug, wait, and retry — then try a different stall and a different network.
- 02Confirm AC charging works normally.
- 03Reboot the car and retry once at a known-good Supercharger.
- 04If it fails at multiple stations, the car-side fast-charge path needs service.
EV systems involved in bms_w162_sw_fc_prechg_too_slow
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
High-voltage distribution & safety
Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.
Severity
Drive and AC-charge normally. If more than one DC station fails the same way, book service before your next road trip.
Estimated repair cost
Dealer / service center
— – —
Often the station, not the car. Car-side repairs are covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_a140_hw_bmb_status_faultBattery Management System — Cell Monitor Hardware Fault Flag
- bms_f025_sw_fc_ctrs_open_undr_ldBattery Management System: Fast-Charge Contactors Opened Under Load
- bms_f107_sw_cell_voltage_sensorBattery Management System: Inaccurate Brick Voltage Measurement
- bms_u007_slowed_chg_batt_coldBattery Management System — Charging Slowed Because the Battery Is Cold