bms_f017_sw_brick_ov
Do not driveTesla · BMS system
Battery Management System: Brick Overvoltage
What it means
A "brick" is a group of cells wired in parallel inside the battery pack. The BMS saw at least one brick report a voltage above the maximum safe limit, so it shut things down to protect the pack. Overvoltage is one of the conditions lithium batteries tolerate least, which is why the car reacts aggressively.
Symptoms
- "Service required / Pull over safely" message
- Car will not drive, charge, or support the low-voltage system
- May appear during or right after charging, especially to 100%
Likely causes (by probability)
- 1.One or more bricks genuinely overcharged (cell imbalance or failing cell group)High
- 2.Faulty voltage sensing on a battery monitoring board (BMB) reporting a false high readingMedium
- 3.Charging system regulation fault pushing voltage too highLow
What you can check yourself
- 01With Scan My Tesla, look at individual brick voltages and find the outlier — screenshot the values for the service visit
- 02Do NOT keep trying to charge to 100%; leave the car unplugged at a moderate state of charge until inspected
- 03Record whether the alert appeared during AC charging, Supercharging, or while parked
- 04Never attempt to open the battery pack or bypass BMS protections — high-voltage components can kill
EV systems involved in bms_f017_sw_brick_ov
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
Low-voltage (12V/16V) system
The small battery and DC-DC converter that power every computer, relay, contactor coil and sensor in the car. EVs are famously sensitive to a weak low-voltage battery — it causes cascading "ghost" faults across unrelated systems.
Severity
Pull over safely and stop driving. An overvoltage brick is a genuine fire-risk category fault — schedule Tesla Service immediately.
Estimated repair cost
Dealer / service center
— – —
Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_w033_sw_crashBattery Management System — Crash Detected (Battery Pyrofuse Blown)
- bms_w138_sw_brick_ov_warningBattery Management System — Cell Group Voltage Above Warning Threshold
- bms_a049_sw_thermal_eventBattery Management System — Potential Thermal Event Detected
- bms_a142_sw_isolation_degradationBattery Management System — Isolation Degraded (Warning Level)