bms_f110_sw_module_vsense
Do not driveTesla · BMS system
Battery Management System: Module Voltage Sensing Mismatch
What it means
Similar to the pack-level check, but at module resolution: the BMS compared total pack voltage to the sum of module voltages and they do not agree. Somewhere in the voltage measurement chain — a sense lead, a connector, or a BMB — the numbers are being corrupted.
Symptoms
- "Service required / Schedule service immediately" message
- Driving, charging, and low-voltage support disabled
- May appear alongside brick or pack voltage mismatch alerts
Likely causes (by probability)
- 1.Module voltage sense wiring or connector faultHigh
- 2.BMB measurement fault on one moduleMedium
- 3.High-resistance internal connection corrupting the readingLow
What you can check yourself
- 01Check for companion alerts bms_f059 (pack mismatch) and bms_f169 (module/brick mismatch) to localize the fault
- 02Screenshot module and brick voltages in Scan My Tesla for the service technician
- 03One full power-down is worth trying; persistent mismatch means hardware
- 04No DIY path — all sense wiring is sealed inside the pack
EV systems involved in bms_f110_sw_module_vsense
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
Low-voltage (12V/16V) system
The small battery and DC-DC converter that power every computer, relay, contactor coil and sensor in the car. EVs are famously sensitive to a weak low-voltage battery — it causes cascading "ghost" faults across unrelated systems.
Severity
Not drivable while active. Bring your logged voltage data to Tesla Service — it shortens diagnosis significantly.
Estimated repair cost
Dealer / service center
— – —
Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_a146_sw_brick_overdischargedBattery Management System — Cell Group Over-Discharged
- bms_f029_sw_current_sensor_resetBattery Management System: Current Sensor Hard Reset
- bms_f123_sw_internal_isolationBattery Management System: Low Internal Isolation
- bms_u014_not_enough_pwr_to_heatBattery Management System — Not Enough Power to Heat the Battery While Charging