All codes

bms_w027_sw_drive_iso_repeated

Do not drive

Tesla · BMS system

Battery Management System — Repeated Loss of High-Voltage Isolation While Driving

What it means

"Isolation" is the electrical separation between the high-voltage system and the car's body — it's what protects you from shock. The BMS detected isolation dropping below the safe threshold multiple times while driving, and after repeated events it locks the car out: it won't start again until the isolation counter is manually reset during service.

Symptoms

  • Car won't start after the events
  • Possible earlier intermittent isolation warnings
  • Symptoms may worsen in wet weather or after washing/flooding
  • May follow collision or underbody damage

Likely causes (by probability)

  1. 1.Moisture or water intrusion into a high-voltage component (pack, drive unit, heater, compressor)High
  2. 2.Damaged high-voltage cabling or connectorsMedium
  3. 3.A failing high-voltage component with internal insulation breakdownMedium
  4. 4.A faulty isolation sensorLow

What you can check yourself

  • 01Note the conditions for each event — rain, car wash, flood, charging — that pattern is gold for diagnosis.
  • 02Check for signs of water intrusion or past flood/collision history.
  • 03Scan for companion isolation alerts with Scan My Tesla.
  • 04Do not probe or open any high-voltage component — isolation faults are a genuine shock hazard and strictly a professional job.

EV systems involved in bms_w027_sw_drive_iso_repeated

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Cabin HVAC

The heat pump / A/C compressor, cabin blower and valves that move heat between battery, motors and cabin. In a heat-pump car, cabin comfort and battery conditioning share one refrigerant loop, so HVAC faults often follow thermal-system faults.

High-voltage battery pack

The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.

High-voltage distribution & safety

Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.

Severity

Do not drive

Repeated isolation loss is a real electrical-safety issue. The car is right to refuse to start — tow it to Tesla Service.

Estimated repair cost

Dealer / service center

— – —

Covered under battery warranty in many cases if pack-related; out-of-warranty cost varies — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site