bms_f073_sw_unexpctd_hv_sys_bhvr
Do not driveTesla · BMS system
Battery Management System: Unexpected High-Voltage Bus Behavior
What it means
During precharge, the BMS watches the high-voltage bus voltage ramp up in a predictable pattern. This alert means the bus did something abnormal — voltage rose too fast, too slow, or erratically — which usually points to an unexpected load or short somewhere on the high-voltage system outside the pack.
Symptoms
- "Unable to start vehicle / Service required" message
- Startup sequence fails before contactors close
- May appear alongside precharge-related alerts
Likely causes (by probability)
- 1.Fault in a high-voltage component on the bus (drive inverter, DC-DC converter, onboard charger)Medium
- 2.Short or partial short on the high-voltage busMedium
- 3.Precharge circuit or sensing fault inside the packLow
What you can check yourself
- 01Do not repeatedly retry starting — failed precharge attempts stress the precharge resistor
- 02Check for companion alerts (bms_f063, bms_f086, bms_f149) to localize the failure
- 03Note any recent work on drive units, charger, or DC-DC converter — recently disturbed components are prime suspects
- 04High-voltage bus diagnosis requires Tesla equipment — no DIY path
EV systems involved in bms_f073_sw_unexpctd_hv_sys_bhvr
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
High-voltage distribution & safety
Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.
Severity
Not drivable. Limit start attempts and arrange a tow to Tesla Service for high-voltage bus diagnosis.
Estimated repair cost
Dealer / service center
— – —
Cost depends on which bus component failed; covered under battery/drive-unit warranty in many cases — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_f062_sw_ctr_pwr_supplyBattery Management System: Contactor Power Supply Low
- bms_f153_sw_neg_contactor_weldedBattery Management System: Negative Contactor Welded
- bms_w016_sw_thermal_gradientBattery Management System — Large Temperature Spread Between Battery Modules
- bms_w100_hw_bmb_resetBattery Management System — Battery Monitoring Board (BMB) Reset Event