bms_f107_sw_cell_voltage_sensor
Do not driveTesla · BMS system
Battery Management System: Inaccurate Brick Voltage Measurement
What it means
The BMS determined that at least one brick's reported voltage is not accurate — the reading does not match reality as cross-checked against other measurements. The car cannot safely charge or discharge cells it measures incorrectly, so it disables the high-voltage system.
Symptoms
- "Service required / Schedule service" message
- Driving, charging, and low-voltage support disabled
- State of charge may have behaved erratically beforehand
Likely causes (by probability)
- 1.Voltage sense harness (VSH) connection problem to the brickHigh
- 2.BMB measurement circuit fault on the affected moduleMedium
- 3.Actual brick behaving abnormally (internal short/open)Low
What you can check yourself
- 01Scan brick voltages with Scan My Tesla — one brick reading implausibly high/low vs. neighbors confirms the location
- 02Check for companion alerts bms_f129 (VSH connector) and bms_f110 (module Vsense)
- 03Try one full power-down to rule out a transient measurement glitch
- 04No DIY path — voltage sense wiring is inside the sealed pack
EV systems involved in bms_f107_sw_cell_voltage_sensor
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Driver assistance sensors & compute
Cameras, radar (on equipped cars), ultrasonic sensors, and the computer that fuses them into Autopilot/FSD and safety features. These systems degrade gracefully: they remove convenience features rather than touching steering, brakes or throttle.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
Severity
Do not drive on bad voltage data. Screenshot the brick readings for service and schedule promptly.
Estimated repair cost
Dealer / service center
— – —
Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_f139_sw_dc_link_v_irrationalBattery Management System: DC Link Voltage Sensor Irrational
- bms_u025_brick_voltage_limitBattery Management System — Maximum Cell Voltage Lowered Due to Pack Wear
- bms_w070_sw_iso_fast_floodBattery Management System — Sudden Loss of Isolation While Driving
- bms_w170_sw_module_overvoltageBattery Management System — Module Voltage Too High