All codes

bms_f169_sw_modulebrick_mismatch

Safe to drive

Tesla · BMS system

Battery Management System: Module vs. Brick Voltage Mismatch

What it means

For one module, the BMS compared the sum of its brick voltages against the module-level voltage reading and they do not match. Since the car is still running, this is logged as a voltage-sensing anomaly to watch rather than a shutdown fault — but it means one of the two measurement paths is drifting.

Symptoms

  • No customer-facing symptoms — log-only alert
  • Vehicle operates normally
  • May precede stronger voltage-sensing faults if it grows

Likely causes (by probability)

  1. 1.Voltage sense wiring or connector issue on that moduleMedium
  2. 2.BMB measurement drift on the moduleMedium
  3. 3.Module-level sense lead problemLow

What you can check yourself

  • 01Identify the affected module in Scan My Tesla and track whether the mismatch grows over weeks
  • 02Watch for escalation to shutdown-level alerts (bms_f107, bms_f110)
  • 03Mention it at your next service visit with the module number noted
  • 04No DIY access — sensing hardware is inside the sealed pack

EV systems involved in bms_f169_sw_modulebrick_mismatch

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

High-voltage battery pack

The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.

Vehicle network (CAN / gateway)

Multiple CAN buses link every controller; the gateway routes messages between them and to diagnostics. "MIA" (missing in action) alerts almost always mean a node stopped sending on its bus — the cause can be the node itself, its wiring, or its power supply.

Severity

Safe to drive

Informational. Track the trend and raise it at your next service visit — no urgent action required.

Estimated repair cost

Dealer / service center

— – —

Usually monitored; pack-internal sensing work is covered under battery warranty in many cases — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site