All codes

bms_f024_sw_ctrs_open_under_load

Do not drive

Tesla · BMS system

Battery Management System: Contactors Opened Under Load

What it means

The BMS detected that the main battery contactors opened while current was still flowing through them. Contactors are only supposed to switch when current is near zero; opening under load creates an arc that damages the contactor surfaces. The car logged this because repeated events can weld or destroy the contactors.

Symptoms

  • Sudden loss of high-voltage power while driving
  • Car may refuse to restart until the condition clears
  • Usually no customer-facing text — often found in service logs

Likely causes (by probability)

  1. 1.Contactor control power interrupted while driving (wiring, connector, or 12V supply issue)Medium
  2. 2.BMS or CPLD logic fault commanding contactors open at the wrong timeMedium
  3. 3.Crash-detection or safety circuit triggering unexpectedlyLow

What you can check yourself

  • 01Record exactly what the car was doing when power was lost (speed, acceleration, bumps in the road)
  • 02Check for companion alerts like bms_f033 (crash detected) or contactor power supply faults
  • 03Inspect the 12V battery health — a weak 12V supply can cause contactor dropouts
  • 04This is not owner-repairable; bring your logged conditions to Tesla Service

EV systems involved in bms_f024_sw_ctrs_open_under_load

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Low-voltage (12V/16V) system

The small battery and DC-DC converter that power every computer, relay, contactor coil and sensor in the car. EVs are famously sensitive to a weak low-voltage battery — it causes cascading "ghost" faults across unrelated systems.

High-voltage distribution & safety

Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.

Vehicle network (CAN / gateway)

Multiple CAN buses link every controller; the gateway routes messages between them and to diagnostics. "MIA" (missing in action) alerts almost always mean a node stopped sending on its bus — the cause can be the node itself, its wiring, or its power supply.

Severity

Do not drive

An unexpected high-voltage disconnect can leave you without power mid-drive. If it recurs, stop driving and have the car towed to service.

Estimated repair cost

Dealer / service center

— – —

Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site