bms_f173_sw_brick6_sense
Safe to driveTesla · BMS system
Battery Management System: Brick 6 Voltage Sense Inconsistency
What it means
The BMS found an inconsistency in how a battery monitoring board reads brick 6 — a specific sense channel used in the pack's measurement scheme. The practical impact is small: full-charge range may drop slightly because the BMS becomes more conservative, but the car keeps working.
Symptoms
- Slight reduction in displayed full-charge range
- No other customer-facing symptoms
- Vehicle charges and drives normally
Likely causes (by probability)
- 1.Sense channel drift or connector resistance on the brick 6 measurement pathMedium
- 2.BMB measurement circuit issue on that channelMedium
- 3.Actual brick 6 behaving differently from the modelLow
What you can check yourself
- 01Track whether displayed range stabilizes or keeps dropping over the next few charge cycles
- 02Compare brick readings in Scan My Tesla to see if one channel looks inconsistent
- 03Mention it at your next service visit — it is a known monitored condition, not an emergency
- 04No DIY access — sense channels are inside the sealed pack
EV systems involved in bms_f173_sw_brick6_sense
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
Drive unit (motor + inverter)
The inverter switches battery DC into the variable AC that spins the motor, and the resolver (position sensor) tells it exactly where the rotor is. Torque control is only as good as that position feedback and the inverter's thermal headroom.
Severity
Drive normally. If the range reduction becomes significant or other voltage-sense alerts appear, schedule service.
Estimated repair cost
Dealer / service center
— – —
Usually monitored; pack-internal work is covered under battery warranty in many cases — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_u002_ramp_down_activeBattery Management System: Battery Ramp-Down Active
- bms_w037_sw_pos_contactorBattery Management System — Positive Contactor Stuck or Welded
- bms_w142_sw_isolation_degradatioBattery Management System — High-Voltage Isolation Degraded (Warning Level)
- bms_a056_sw_standby_supply_faultBattery Management System — Standby Power Supply Fault