All codes

bms_a078_rapid_dch_while_charging

Do not drive

Tesla · BMS system

Battery Management System — High Discharge Current During DC Charging

What it means

While DC fast charging, the BMS saw current flowing out of the battery at a rate that should not happen mid-session. As a safety response, the car refuses to charge until the cable is unplugged and the alert clears. This pattern often points to failing hardware in the fast-charge path rather than the station.

Symptoms

  • DC fast charging session stops and will not resume
  • Car will not charge until the cable is unplugged
  • Silent center-display alert without a chime
  • May repeat at different Superchargers

Likely causes (by probability)

  1. 1.Fault in the fast-charge contactor or DC-link hardwareMedium
  2. 2.Current-sensor misreading during the sessionMedium
  3. 3.DC charging station malfunctionLow
  4. 4.Drive-unit or PCS back-feeding during the sessionLow

What you can check yourself

  • 01Unplug fully, let the car sleep, and try a different Supercharger stall or station — note whether the alert follows the car.
  • 02Switch to AC charging and verify it works normally; that isolates the fault to the DC path.
  • 03Record stall ID, station, and time if it happens at a Supercharger — Tesla can pull station logs.
  • 04Do not attempt to inspect the fast-charge contactors; they are high-voltage components.

EV systems involved in bms_a078_rapid_dch_while_charging

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Driver assistance sensors & compute

Cameras, radar (on equipped cars), ultrasonic sensors, and the computer that fuses them into Autopilot/FSD and safety features. These systems degrade gracefully: they remove convenience features rather than touching steering, brakes or throttle.

High-voltage distribution & safety

Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

Severity

Do not drive

DC fast charging is blocked until resolved. Use AC charging if it still works, and schedule service to check the fast-charge path.

Estimated repair cost

Dealer / service center

— – —

Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site