All codes

bms_w029_sw_current_sensor_reset

Safe to drive

Tesla · BMS system

Battery Management System — Pack Current Sensor Hard Reset (Log)

What it means

The BMS noticed that the battery pack's current sensor went through a hard reset. This alert is essentially a log entry marking that the reset started and completed — informational for service, not a driver-facing problem. On its own it doesn't indicate damage.

Symptoms

  • No driver-facing symptom in most cases
  • May appear in logs alongside other electrical alerts

Likely causes (by probability)

  1. 1.A one-off sensor glitch or power interruption to the sensorMedium
  2. 2.Low or unstable 12V supply upsetting the sensorMedium
  3. 3.A developing fault in the sensor or its wiring (only if it repeats)Low

What you can check yourself

  • 01Note whether it was a one-time event or repeats in the alert history.
  • 02Check 12V battery health if it recurs.
  • 03If it appears together with current-sensing or contactor alerts, share the full log with Tesla Service.

EV systems involved in bms_w029_sw_current_sensor_reset

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Driver assistance sensors & compute

Cameras, radar (on equipped cars), ultrasonic sensors, and the computer that fuses them into Autopilot/FSD and safety features. These systems degrade gracefully: they remove convenience features rather than touching steering, brakes or throttle.

High-voltage battery pack

The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.

High-voltage distribution & safety

Contactors (big relays that connect the pack to the car), the pyrofuse (a one-shot crash disconnect), precharge circuitry, and the isolation monitor that constantly checks high voltage is not leaking to the chassis. Faults here are treated as safety-critical.

Severity

Safe to drive

A single occurrence is background noise. Only recurring resets alongside other alerts deserve a service conversation.

Estimated repair cost

Dealer / service center

— – —

No repair expected for an isolated log entry; recurring sensor faults are often covered under battery warranty — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site