bms_w169_sw_modulebrick_mismatch
Safe to driveTesla · BMS system
Battery Management System — Module Voltage Reading Mismatch
What it means
The BMS adds up the individual cell group voltages inside a module and compares that sum against what the module-level voltage sensor reports. The two numbers did not agree. This is mainly a logging alert, but it can point to a problem with the voltage sensing hardware inside the pack.
Symptoms
- No noticeable driving symptoms
- Silent alert on the center display (no chime)
- May appear together with other voltage-sensing alerts
- Possible inaccurate state-of-charge or range estimates over time
Likely causes (by probability)
- 1.A failing voltage sense line or battery monitoring board (BMB) inside the packMedium
- 2.Loose or corroded connector on the internal sense harnessMedium
- 3.A genuinely abnormal cell group pulling the module sum offLow
What you can check yourself
- 01Record when the alert appears and whether it keeps coming back — a one-time event is less concerning
- 02Use Scan My Tesla to look for unusual brick voltage readings if you have access
- 03Check for related alerts (BMS_w177, HVBATT_a742) that would confirm a sense-harness problem
- 04Do NOT open or probe the battery pack — internal sense wiring is high-voltage territory for Tesla Service only
EV systems involved in bms_w169_sw_modulebrick_mismatch
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Driver assistance sensors & compute
Cameras, radar (on equipped cars), ultrasonic sensors, and the computer that fuses them into Autopilot/FSD and safety features. These systems degrade gracefully: they remove convenience features rather than touching steering, brakes or throttle.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
Severity
You can keep driving, but mention it to Tesla Service — especially if it repeats. Repeated sense mismatches can hide real cell problems.
Estimated repair cost
Dealer / service center
— – —
Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_a095_sw_ui_miaBattery Management System — Touchscreen Not Responding
- bms_a178_sw_uncontrolled_regen_pwrbBattery Management System — Uncontrolled Regen Event (Track Mode)
- bms_f073_sw_unexpctd_hv_sys_bhvrBattery Management System: Unexpected High-Voltage Bus Behavior
- bms_f164_sw_brick_soc_imbalanceBattery Management System: Brick State-of-Charge Imbalance