bms_w089_sw_thc_mia
Do not driveTesla · BMS system
Battery Management System — Thermal Controller (THC) Not Responding
What it means
The BMS has lost CAN communication with the thermal controller — the module that runs the heating and cooling hardware for the battery and powertrain. Without thermal management data and control, the BMS can't protect the pack, so driving, charging, and 12V support are shut down.
Symptoms
- Car may not drive or charge
- HVAC or battery temperature warnings may appear alongside
- "Service needed" style alert
- May be intermittent — often communication-related
Likely causes (by probability)
- 1.Failed thermal controller moduleMedium
- 2.CAN bus wiring or connector fault between the BMS and THCMedium
- 3.Low/unstable 12V supply knocking modules offlineMedium
What you can check yourself
- 01Check the 12V battery — a weak one commonly knocks modules off the CAN bus.
- 02Try one full power-off and restart.
- 03Check for pending software updates.
- 04If it persists, the module or its wiring needs Tesla Service diagnosis.
EV systems involved in bms_w089_sw_thc_mia
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Cabin HVAC
The heat pump / A/C compressor, cabin blower and valves that move heat between battery, motors and cabin. In a heat-pump car, cabin comfort and battery conditioning share one refrigerant loop, so HVAC faults often follow thermal-system faults.
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
Thermal management (cooling loop)
Pumps, valves, fans and coolant loops that keep the battery, motors, power electronics and cabin in their happy temperature bands. An EV derates power and charging speed long before anything overheats, so most thermal codes are about prevention, not damage.
Severity
Without thermal control the car protects the battery by shutting down. Rule out the 12V battery, then tow to service.
Estimated repair cost
Dealer / service center
— – —
If it's a 12V issue the fix is cheap; module or wiring repairs vary — covered under warranty in many cases. Get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- bms_f017_sw_brick_ovBattery Management System: Brick Overvoltage
- bms_f100_hw_bmb_resetBattery Management System: Battery Monitoring Board Power-On Reset
- bms_u003_insufficient_drive_pwrBattery Management System: Insufficient Power to Drive
- bms_w038_sw_neg_contactorBattery Management System — Negative Contactor Stuck or Welded