hvbatt_a745_bp1socimbalance
Drive with cautionTesla · HVBATT system
High-Voltage Battery — State-of-Charge Imbalance, Max Charge Capped at 50%
What it means
The BMS sees too big a gap between the most-charged and least-charged cell groups in the pack. To protect the weak end, it caps the maximum state of charge at about 50%. You keep full driving safety, but roughly half your range is off the table until the imbalance is resolved.
Symptoms
- Maximum charge limited to about 50%
- Roughly half the usual range
- No customer-facing message in most cases
- Charging stops early even when set higher
Likely causes (by probability)
- 1.A weak or self-discharging cell group pulling one section downHigh
- 2.Long-term imbalance beyond what passive balancing can fixMedium
- 3.Sense-harness issue making one group look low (check for VSH alerts)Low
What you can check yourself
- 01Check brick voltages in Scan My Tesla to see how far the low group has drifted
- 02Try a long AC charge session at whatever ceiling is allowed — balancing still runs
- 03Look for companion alerts (a722 SOC limiting, VSH faults) for the full picture
- 04Do not attempt pack work; if the cap persists for weeks, push for battery service under warranty
EV systems involved in hvbatt_a745_bp1socimbalance
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Vehicle network (CAN / gateway)
Multiple CAN buses link every controller; the gateway routes messages between them and to diagnostics. "MIA" (missing in action) alerts almost always mean a node stopped sending on its bus — the cause can be the node itself, its wiring, or its power supply.
Severity
Drivable but with about half the range. A persistent 50% cap is strong evidence for a warranty battery claim — document it and schedule service.
Estimated repair cost
Dealer / service center
— – —
Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- hvbatt_a248_acjbcplinerelayweldedHigh-Voltage Battery — Charge Port Line Relay Welded (ACJB)
- hvbatt_a722_bp1dsoclimitingHigh-Voltage Battery — Charging Capped at ~50% Because of a Weak Cell Group
- hvbatt_a742_vshfailureHigh-Voltage Battery — Voltage Sense Harness Failure
- hvbatt_a237_bmsassertedcpfaultlineHigh-Voltage Battery — BMS Declared a Charge Port Fault (Welded Contactor)