All codes

hvbatt_a248_acjbcplinerelaywelded

Drive with caution

Tesla · HVBATT system

High-Voltage Battery — Charge Port Line Relay Welded (ACJB)

What it means

The BMS detected that a relay in the AC junction box — the one on the charge port line — is welded shut. With that relay stuck, the car disables the power outlets (on Cybertruck) and blocks DC fast charging, while AC charging still works.

Symptoms

  • "Outlets and DC charging unavailable" message
  • "OK to AC charge — Service required" instruction
  • Bed/cabin power outlets will not turn on (Cybertruck)
  • DC fast charging sessions fail to start

Likely causes (by probability)

  1. 1.Welded charge port line relay in the AC junction boxHigh
  2. 2.Relay driver circuit fault causing a false welded readingLow
  3. 3.Damage from a prior overcurrent or short on the outlet circuitLow

What you can check yourself

  • 01Confirm AC charging still works so you can keep the pack topped up
  • 02Stop using the power outlets and DC fast charging until it is fixed
  • 03Check for the related "may be welded" alert (a278) or neutral relay alert (a249)
  • 04Relay replacement is inside the high-voltage junction box — leave it to Tesla Service

EV systems involved in hvbatt_a248_acjbcplinerelaywelded

High-voltage battery pack

The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.

Charging system

The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.

Battery management system (BMS)

The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.

Drive unit (motor + inverter)

The inverter switches battery DC into the variable AC that spins the motor, and the resolver (position sensor) tells it exactly where the rotor is. Torque control is only as good as that position feedback and the inverter's thermal headroom.

Severity

Drive with caution

You can drive and AC charge normally. You have lost outlets and DC fast charging, so plan trips around AC charging and book service.

Estimated repair cost

Dealer / service center

— – —

Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.

DIY

Not DIY-safe — professional repair recommended.

Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.

Content pending community verification. This entry is based on public owner reports and general repair knowledge. Exact part numbers, prices and procedures vary by model year — confirm with your service documentation before acting. Not affiliated with any vehicle manufacturer.

What to read next

Related fault codes

Other alerts from the same failure family — useful for cross-checking symptoms.

Featured on NewTool.site