hvbatt_a249_acjbcpneutralrelaywelded
Drive with cautionTesla · HVBATT system
High-Voltage Battery — Charge Port Neutral Relay Welded (ACJB)
What it means
The BMS found the neutral relay in the AC junction box welded closed. Same practical result as its line-side twin: the power outlets go offline and DC fast charging is blocked, but AC charging keeps working.
Symptoms
- "Outlets and DC charging unavailable" message
- "OK to AC charge — Service required" instruction
- Power outlets disabled (Cybertruck)
- DC fast charging will not start
Likely causes (by probability)
- 1.Welded neutral relay in the AC junction boxHigh
- 2.False welded detection from a sensing circuit faultLow
- 3.Prior overcurrent event on the outlet circuitLow
What you can check yourself
- 01Verify AC charging works and use it to stay charged
- 02Avoid DC fast charging attempts and outlet use until repaired
- 03Look for companion ACJB relay alerts (a248, a278) that fill out the picture
- 04Do not attempt any work inside the high-voltage junction box — schedule service
EV systems involved in hvbatt_a249_acjbcpneutralrelaywelded
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Vehicle network (CAN / gateway)
Multiple CAN buses link every controller; the gateway routes messages between them and to diagnostics. "MIA" (missing in action) alerts almost always mean a node stopped sending on its bus — the cause can be the node itself, its wiring, or its power supply.
Severity
Drive and AC charge as normal, but outlets and DC fast charging are down until the relay is replaced. Book service when convenient.
Estimated repair cost
Dealer / service center
— – —
Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- hvbatt_a736_bp1cacimbalancelimpHigh-Voltage Battery — Capacity Imbalance Triggering Limp Mode (Section 1)
- hvbatt_a122_isolationdegradationHigh-Voltage Battery — Isolation Degrading (Early Warning)
- hvbatt_a262_acjbbedl1relayweldedHigh-Voltage Battery — Bed Outlet Line 1 Relay Welded (ACJB)
- hvbatt_a735_bp2cacimbalancelimitingHigh-Voltage Battery — Cell Capacity Imbalance Limiting Performance (Section 2)