hvbatt_a262_acjbbedl1relaywelded
Drive with cautionTesla · HVBATT system
High-Voltage Battery — Bed Outlet Line 1 Relay Welded (ACJB)
What it means
The BMS detected that the relay feeding the bed outlet (line 1) in the AC junction box is welded shut. The protective response flips the usual pattern: AC charging is disabled while DC fast charging still works, and the outlets are off.
Symptoms
- "AC charging unavailable — OK to DC fast charge" message
- "Service needed to restore AC charging" instruction
- Bed outlets will not power on (Cybertruck)
- Home/work AC charging sessions fail to start
Likely causes (by probability)
- 1.Welded bed outlet line 1 relay in the AC junction boxHigh
- 2.False welded detection from a sensing faultLow
- 3.Damage from a short or overload on the bed outlet circuitLow
What you can check yourself
- 01Switch to DC fast charging to keep the pack charged until service
- 02Do not keep retrying AC sessions — the relay is physically stuck
- 03Note anything plugged into the bed outlets recently (high-load tools, etc.)
- 04Relay work inside the ACJB is high-voltage service work — do not DIY
EV systems involved in hvbatt_a262_acjbbedl1relaywelded
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Vehicle network (CAN / gateway)
Multiple CAN buses link every controller; the gateway routes messages between them and to diagnostics. "MIA" (missing in action) alerts almost always mean a node stopped sending on its bus — the cause can be the node itself, its wiring, or its power supply.
Severity
You can drive and DC fast charge, but home AC charging is down. If you rely on home charging, treat this as urgent and schedule service now.
Estimated repair cost
Dealer / service center
— – —
Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- hvbatt_a237_bmsassertedcpfaultlineHigh-Voltage Battery — BMS Declared a Charge Port Fault (Welded Contactor)
- hvbatt_a281_acjbbedl3relaymaybeweldedHigh-Voltage Battery — Bed Outlet Line 3 Relay Suspected Welded (ACJB)
- hvbatt_a737_bp2cacimbalancelimpHigh-Voltage Battery — Capacity Imbalance Triggering Limp Mode (Section 2)
- hvbatt_a123_isolationfailureindrivewarningHigh-Voltage Battery — Repeated Isolation Faults Across Drives