hvbatt_a736_bp1cacimbalancelimp
Drive with cautionTesla · HVBATT system
High-Voltage Battery — Capacity Imbalance Triggering Limp Mode (Section 1)
What it means
The capacity imbalance inside one pack section has crossed the line from "limit performance" to "limp mode." The BMS is now actively restricting the battery to protect the weak cell groups, and acceleration and charging are both noticeably reduced. A separate alert will confirm the car is in limp mode.
Symptoms
- "High-voltage battery needs service" message
- "Acceleration and charging performance reduced" warning
- Sluggish acceleration and capped charging speed
- Maximum range significantly reduced
Likely causes (by probability)
- 1.A genuinely failing cell group inside the first pack sectionHigh
- 2.Rapidly progressing internal short in one or more cellsMedium
- 3.Faulty capacity measurement (much less likely at limp level)Low
What you can check yourself
- 01Drive gently — the pack is protecting itself and needs service, not more stress
- 02Note your remaining range and charging speeds for the service report
- 03Check which companion alerts are set (a734, w723) to give service the full picture
- 04Do not attempt any pack-level intervention — limp mode means the imbalance is real and internal
EV systems involved in hvbatt_a736_bp1cacimbalancelimp
High-voltage battery pack
The traction battery — hundreds of lithium-ion cells grouped into modules, plus the sense harness that reports every cell group's voltage and temperature. It is the single most expensive component in the car, and most battery-related alerts originate from measurements taken here.
Charging system
The charge port, onboard charger (AC), fast-charge controller (DC/CHAdeMO/GB-T), and all the communication protocols that negotiate current between the car and the charging station. Failures split cleanly into power problems and communication problems.
Battery management system (BMS)
The pack's dedicated computer. It balances cells, estimates state of charge and health, controls the main contactors, watches isolation, and decides when the pack must limit power or refuse to operate. Nearly every "the battery says no" behavior traces back to the BMS.
Drive unit (motor + inverter)
The inverter switches battery DC into the variable AC that spins the motor, and the resolver (position sensor) tells it exactly where the rotor is. Torque control is only as good as that position feedback and the inverter's thermal headroom.
Severity
You can still drive, but with reduced power and range. Get to Tesla Service soon — limp mode on capacity imbalance usually ends in pack-level repair, hopefully under warranty.
Estimated repair cost
Dealer / service center
— – —
Covered under battery warranty in many cases; out-of-warranty cost varies — get a quote from Tesla Service.
DIY
Not DIY-safe — professional repair recommended.
Estimated ranges based on owner reports. Actual pricing varies by model, year, region and warranty status.
What to read next
Related fault codes
Other alerts from the same failure family — useful for cross-checking symptoms.
- hvbatt_a745_bp1socimbalanceHigh-Voltage Battery — State-of-Charge Imbalance, Max Charge Capped at 50%
- hvbatt_a248_acjbcplinerelayweldedHigh-Voltage Battery — Charge Port Line Relay Welded (ACJB)
- hvbatt_a722_bp1dsoclimitingHigh-Voltage Battery — Charging Capped at ~50% Because of a Weak Cell Group
- hvbatt_a742_vshfailureHigh-Voltage Battery — Voltage Sense Harness Failure